I seem to have amassed some sweet earrings over the last few years and I was running out of space to store them. I wanted to be able to see them all the time that way I would remember they were there and actually wear them. I searched around online for ideas and I found this page:
I had random frames in my office from my thrift store trips. I can't seem to pass up a cheap, sturdy frame when I'm at a thrift store. I always feel like they'll come in handy somewhere down the line, and it proved to be correct!
Below is my step-by-step process of how I made my own earring picture frame holders. I did this earlier this year around August, so hopefully I'll remember all the important steps. Enjoy!
1. A sampling of my thrift store frames. I usually spend $2.00 - $7.00 on assorted sizes:
2. I took apart the frames, getting rid of the glass and the awesome 1960's & 1970's artwork:
3. On the backs of the frames, I removed all the staples/nails that secured the backing of the frame:
4. I chose gold and silver spray paint because I'm so classy:
5. Outside, I spray painted each of the frames, giving some time to dry between coats. I did 2-3 light coats of paint. And because it was a million degrees outside this summer, it dried in no time!
6. Using plastic screen door material, I cut squares roughly 2-3 inches bigger than the frame I was working on. Using a hot glue gun, I would glue small sections of the screen to the frame pulling the screen taut. (Every time I type or say 'taut', I automatically say "Tight like a tiger." Thanks Goldmember.)
7. I wanted the screen to be very taut (I just did it again) and secure, so I glued the small sections by rotating all four sides of the frame, instead of gluing one whole side at a time.
Trying to explain it now is proving difficult, but I started on one side in the middle of the frame and hot glued the section. Once it dried, I went to the oppisite side of the frame, directly across from my first glued section, and pulled it tight and then glued that section. Once that was dry, I went to the third side of the frame and pulled it tight and hot glued it in the center of that side. Once all four sides had a secure section in the center that was hot glued, I worked out from there, slowly gluing the screen to the frame while keeping it held tight.
(On a side note, I attempted to use a staple gun to secure the screen and I couldn't get the screen to stay tight on the frame. The hot glue method is slow and steady, but I think it is worth it in the end.)
8. Once the screen was completely glued into the frame and the glue was cooled and dried, I trimmed the left over screen from around the frame:
Here are the finished products! I really like them because they are GREAT storage and they look super artsy-fartsy!
No comments:
Post a Comment